Hydraulic Hose Fitting for Marine Applications Availability: Within 1-2 working days
This SAE Standard covers general and performance specifications for hydraulic hose fittings of the styles, types, and classes defined in Section 3 and used in conjunction with nonmetallic flexible hos...
Emulsified Water/Fuel Separation Test Procedure Availability: Within 1-2 working days
To determine the ability of a fuel/water separator to separate emulsified or finely dispersed water from fuels....
Hose Clamp Specifications Availability: Within 1-2 working days
This SAE Standard covers thirty-two (32) types of clamps most commonly and suitably being used on OEM coolant, fuel, oil, vacuum, and emission systems....
Accommodation Tool Reference Point Availability: Within 1-2 working days
Reference lines have been developed to which driver workspace accomodation tools can be located in vehicle space. The lines describe horizontal reference point locations as a function of vehicle H-poi...
Truck Driver Shin-Knee Position for Clutch and Accelerator Availability: Within 1-2 working days
This SAE Recommended Practice describes two-dimensional, 95th percentile truck driver, side view, seated shin-knee contours for both the accelerator operating leg and the clutch operating leg for hori...
Truck Driver Stomach Position Availability: Within 1-2 working days
This SAE Recommended Practice describes two-dimensional 95th percentile truck driver side view, seated stomach contours for horizontally adjustable seats (see Figure 1). There is one contour and three...
Marine Fuel Hoses Availability: Within 1-2 working days
This SAE Standard specifies requirements for two types, three classes and four styles of reinforced hose and non-reinforced tubing for conveying gasoline or diesel fuel aboard small craft including pl...
Fusible Links Availability: Within 1-2 working days
This standard covers supplemental requirements for low tension primary cable intended for use as Fusible Links (Fuse Links) at a nominal system voltage of 60 V DC (25 V AC) or less in surface vehicle ...
Vehicle Aerodynamics Terminology Availability: Within 1-2 working days
This terminology is intended to provide a common nomenclature for use in publishing road vehicle aerodynamics data and reports....
Rubber Cups for Hydraulic Actuating Cylinders Availability: Within 1-2 working days
These specifications cover molded cups 51 mm (2 in) in diameter and under, compounded from high temperature resistant rubber for use in hydraulic actuating cylinders employing motor vehicle brake flui...
Headlamp Design Guidelines for Mature Drivers Availability: Within 1-2 working days
This SAE Information Report should be used as a supplement to SAE J1383. It is intended to provide additional information which is important to the automotive designer and engineer in the process of d...
Performance Criteria for Electronic Refrigerant Leak Detectors Availability: Within 1-2 working days
This SAE Standard applies to electronic probe-type leak detectors used to service motor vehicle passenger compartment air-conditioning systems. This document does not address any safety issues concern...
Low Tension Wiring and Cable Terminals and Splice Clips Availability: Within 1-2 working days
The SAE Recommended Practice covers the application requirements for terminals and splice clips attached to stranded low tension wiring and cable as shown in SAE J1127 and SAE J1128. In addition, it c...
Airbag Module Deployment Test Procedure Availability: Within 1-2 working days
This SAE Recommended Practice describes a method to be used for the static deployment of airbag module assemblies. The results obtained from the deployment tests will be used to verify compliance with...
Radiator Caps and Filler Necks Availability: Within 1-2 working days
This SAE Standard was developed primarily for passenger car and truck application, but may be used in marine, industrial, and similar applications....
