That our construction special inspectors are trained as experts. This book provides the necessary materials for training an inspector for this high sensitive position. It also can be used as a handy reference book, in case there is an area or situation, where a written material can be helpful.
Introduction
Preface
Chapter 1 : General Guidelines for Field Inspectors
Chapter 2 : General Guidelines for Earthwork Inspection
Chapter 3 : General Guidelines for Reinforcing Steel Inspection
Chapter 4 : General Guidelines for Concrete Inspection
Chapter 5 : Making and Curing Concrete Test Specimens in The Field
Chapter 6 : Compressive Strength of Concrete Cylinder
Chapter 7 : Unit Weight, Yield and Air Content (Gravimetric) of Concrete
Chapter 8 : Slump of Hydraulic Cement Concrete
Chapter 9 : Sampling Freshly Mixed Concrete
Chapter 10 : Making and Curing Concrete Test Specimens in The Laboratory
Chapter 11 : Air Content of Freshly Mixed Concrete by Pressure Method
Chapter 12 : Capping Cylindrical Concrete Specimens
Chapter 13 : Temperature of Freshly Mixed Portland Cement Concrete
Chapter 14 : General Guidelines for Concrete Batch Plant Inspection
Chapter 15 : General Guidelines for Pre-Tensioned Concrete Inspection
Chapter 16 : General Guidelines for Post-Tensioned Concrete Inspection
Chapter 17 : General Guidelines for Masonry Inspection
Chapter 18 : General Guidelines for Asphaltic Concrete Inspection
Chapter 19 : General Guidelines for Shotcrete Inspection
Chapter 20 : General Guidelines for Structural Steel Inspection
Chapter 21 : General Guidelines for Nondestructive Testing
Chapter 22 : General Guidelines for Spray-Applied Fireproofing Inspection, Part I
Chapter 23 : General Guidelines for Spray-Applied Fireproofing Inspection, Part II
Chapter 24 : General Guidelines for Glu Lam and Truss Joists Inspection
Chapter 25 : Guidelines for Special Inspection of Anchor Bolts, Dowels, and Holdown Systems Installations
Chapter 26 : Standard Test Method for Penetration Resistance of Hardened Concrete
Chapter 27 : Standard Test Method for Determining Floor Flatness and Levelness using The F-Number System
Chapter 28 : Exterior Insulation and Finish System (E.I.F.S) Inspection
Chapter 29 : Guidelines for Handling Test Samples
Chapter 30 : Classification of Soils for Engineering Purposes
Chapter 31 : Guidelines for Sampling Aggregates
Chapter 33 : Organic Impurities in Fine Aggregates for Concrete
Chapter 34 : Meterials Finer Than No. 200 Sieve in Mineral Aggregate by Washing
Chapter 35 : Method of Test for Determination of Degradation Value
Chapter 36 : Standard Test Method for Rebound Number of Hardened Concrete
Chapter 37 : Turbidity Monitoring Requirements
Chapter 38 : Fundamentals of Bridge Inspection
Chapter 39 : Inspection of Bridges for Scour
About The Author
Appendix
References