Tab Article
Preface and Scope
Introduction
SECTION 1 - GENERAL REQUIREMENTS
1.1 - Safety
1.2 - Required competence
1.3 - The client
1.4 - Alterations and additions
1.5 - Record keeping
SECTION 2 - INITIAL VERIFICATION
2.1 - Purpose of initial verification
2.2 - Certificates
2.3 - Required information
2.4 - Scope
2.5 - Frequency of subsequent inspections
2.6 - Initial inspection
2.7 - Initial testing
SECTION 3 - PERIODIC INSPECTION AND TESTING
3.1 - Purpose of periodic inspection and testing
3.2 - Necessity for periodic inspection and testing
3.3 - Electricity at Work Regulations
3.4 - Design
3.5 - Routine checks
3.6 - Required information
3.7 - Frequency of inspection
3.8 - Requirements for inspection and testing
3.9 - Periodic inspection
3.10 - Periodic testing
SECTION 4 - TEST INSTRUMENTS
4.1 - Instrument standard
4.2 - Instrument accuracy
4.3 - Low-resistance ohmmeters
4.4 - Insulation resistance ohmmeters
4.5 - Applied voltage testers
4.6 - Earth fault loop impedance testers
4.7 - Earth electrode resistance testers
4.8 - RCD testers
SECTION 5 - FORMS
5.1 - Initial inspection and testing
5.2 - Minor works
5.3 - Periodic inspection
Appendix 1 - Resistance of copper and aluminium conductors
Appendix 2 - Maximum permissible measured earth fault loop impedance
Index
